Signed-off-by: Alessandro Rubini <rubini@gnudd.com>

Signed-off-by: Alessandro Rubini <rubini@gnudd.com>

This is the host part of the software-only uart. The lm32 part is
selected at compile time (CONFIG_UART_SW).

The tool, when run, opens one or more pty pairs, and reports to stdout
which is the name of the slave descriptor. You can then run
"minicom -p /dev/pts/XXX" or other commands, to access the software uart.

Signed-off-by: Alessandro Rubini <rubini@gnudd.com>

Signed-off-by: Alessandro Rubini <rubini@gnudd.com>

This doesn't change the behavior of any command, but adds revision.c
as a real source file rather than something created by make using
"echo ... > revision.c".  In any case, the file is recompiled
each time you call "make", so the date and time reflect the last
build.

However, this introduces CONFIG_DETERMINISTIC_BINARY (that nobody
sets at this point in time) to build a binary withouth __DATE__
and __TIME__ strings, so it is the same at every rebuild. See
next commit.

Signed-off-by: Alessandro Rubini <rubini@gnudd.com>

Add the lines from the .gitignore found in bst-kconfig. As in the
previous commit, use bst-kconfig commit v2.6.34-4-g8168c0b

Signed-off-by: Alessandro Rubini <rubini@gnudd.com>