Signed-off-by: Alessandro Rubini <rubini@gnudd.com>

RX LLDP frames worked without any change.

Signed-off-by: Michal Wasiak <michal.wasiak@gmail.com>

Note:
--Checking of checksums was added in v5.0 of firmware
--Added note about limiting the size od LLDP frame

Signed-off-by: Kinga Wujek <dev_public@wujek.eu>

Maciej Lipinski authored 4 years ago and Grzegorz Daniluk committed 4 years ago

- behavior for different VLAN modes was incorrect (in table and text)
- updates per changes in v6.0 were needed.

Adam Wujek authored 6 years ago and Grzegorz Daniluk committed 5 years ago

Move wrsPtpInstanceName to be the first (after indexes) OID.
Thanks to this, by doing snmpwalk/snmpgetnext of OID wrsPtpInstanceName(.<n>.<m>),
the user gets in a single responce:
--n - a port number
--m - an instance nubmer
--value which is an instance name

Signed-off-by: Adam Wujek <adam.wujek@cern.ch>

Adam Wujek authored 6 years ago and Grzegorz Daniluk committed 5 years ago

Signed-off-by: Adam Wujek <adam.wujek@cern.ch>

Signed-off-by: Adam Wujek <adam.wujek@cern.ch>

Signed-off-by: Adam Wujek <adam.wujek@cern.ch>

dropbear was replaced, because it does not support correctly LDAP+kerberos.

It was almost working. With LDAP+Kerberos over PAM dropbear was prompting once
more for a password when the correct was given.

Signed-off-by: Adam Wujek <adam.wujek@cern.ch>

Include again the commit:
[BUG: 1575] userspace: add "monitor" port parameter to HAL and snmp
74e16153



This time on top of HA

Signed-off-by: Adam Wujek <adam.wujek@cern.ch>

Take the HA first

This reverts commit 74e16153.

Signed-off-by: Adam Wujek <adam.wujek@cern.ch>

Signed-off-by: Adam Wujek <adam.wujek@cern.ch>

Signed-off-by: Adam Wujek <adam.wujek@cern.ch>

Signed-off-by: Adam Wujek <adam.wujek@cern.ch>

For rnabling 50ohm termination for 1-PPS input
It is set from HAL.

Signed-off-by: Adam Wujek <adam.wujek@cern.ch>

NOTE: This option is not supported yet by the PPSI.

Signed-off-by: Adam Wujek <adam.wujek@cern.ch>