Disable waiting dhcp forever when starting up.

Release v6.0.2 of WR Switch firmware

Disable web interface in the default config due to security
vulnerabilities described in CVE-2023-22577.

Fix setting time at startup when in GM mode.

Fix build errors on ubuntu 20.04

/etc/init.d/wr_date gets parameter "ppsi" to avoid redirect of the
output and setting the date from /update/saved_date if unable to get
the data via ntp.

Signed-off-by: Adam Wujek <dev_public@wujek.eu>

Don't kill other ntpd instances.

Signed-off-by: Adam Wujek <dev_public@wujek.eu>

This fix solves the problem of jumps of a fraction of a second during
the startup. It is believed that the problem is in HDL, this commit is
just a workaround implemented in software.

Signed-off-by: Adam Wujek <dev_public@wujek.eu>

Signed-off-by: Adam Wujek <dev_public@wujek.eu>

Disable web interface in the default config due to security
vulnerabilities described in CVE-2023-22577.

Please note that web interface can still be enabled manually in the
config file in runtime.

Signed-off-by: Adam Wujek <dev_public@wujek.eu>

Signed-off-by: Adam Wujek <dev_public@wujek.eu>

Before it was printed as signed

Signed-off-by: Adam Wujek <dev_public@wujek.eu>

Signed-off-by: Adam Wujek <dev_public@wujek.eu>

  update wrsfl_release_defconfig
  update tx_phase_cal.conf

    USB-to-SFP management port.

  A kernel module file asix.ko and a tool ioctl will be generated.
  After insmod the asix.ko, a new network interface, eth1, will be found.

see: ppsi#25

Maciej Lipinski authored 4 years ago and Grzegorz Daniluk committed 4 years ago

softPLL was set in BC mode and current_reference changed during
the measurment. The problemw as that the before-measurement
setting was not recovered. This caused problems, in particular
during LPDC rx calibration of other ports.

Maciej Lipinski authored 4 years ago and Grzegorz Daniluk committed 4 years ago

printf makes the messages to be logged in syslog in strange order
with respect to the other messages. It's best to use pr_* consistently.

Nico Coesel authored 6 years ago and Grzegorz Daniluk committed 4 years ago

NC: Add patches for 1GB NAND flash on SCB3.4.1. These patches are (tested) backwards compatible with the original SCB3.4.

Maciej Lipinski authored 4 years ago and Grzegorz Daniluk committed 4 years ago

In the rx calib FSM, this is needed to over the case when the
calibration is re-started (INIT state entered) during execution
of the FSM (e.g. due to link unplugging, or timeout).

In the tx calib FSM, in theory this is not needed, yet it seems
clean and it might be needed in the future if some sort of
reset is implemented.