Explore projects

DIOT reliability studies files and reports. More info at the Wiki page

FmcDIO32chTTLa is a 32-bit port digital IO card in FMC form-factor. More info at the Wiki page

Specific applications of open hardware modules are subprojects of this project. These subprojects contain specific firmware and/or software for existing hardware projects.

A High Pin Count FMC carrier in VXS format with two Virtex 5 FPGAs plus a DSP on board.

PC/104 modules. PC/104 (or PC104) is a family of embedded computer standards which define both form factors and computer buses. The standard is modular, and allows to stack together boards from a variety of COTS manufacturers to produce a customized embedded system. The designs are in sub-projects.

The Fmc ADC 100M 14b 16cha DAC 2M 14B 4cha is a 16 channel 100MSPS 14 bit ADC and 4 channel 2MSPS 14 bit DAC card in FMC (FPGA Mezzanine Card) format. The board is also equipped with 4 DIO channels.

Local image descriptors are calculated for every 800x600 image up to 36 fps. All implemented in Handel-C, they provide energy with unsigned 8 bit fixed-point precision, as well as phase and orientation with Q7.2. The implementation is based on a multi-oriented bank of Gabor filters.

Gateware (HDL design) for FMC ADC 100M 14b 4cha on SPEC and SVEC carriers.

Hardware design of Conv TTL Blocking. Includes schematics, PCB layout and manufacturing files. More info at the Wiki page

An LPC FMC board which seeks to distribute digital I/O. It is designed to operate at least at 10 MHz, however a better design could allow this board to operate at much higher frequencies. This board is compatible with "PMOD" Connectors.

CompactRIO module with White Rabbit functionality. LabVIEW support, front-panel connector with 10 I/O lines.

More info at the Wiki page

Neo51 is an open source hardware based on 89V51 microcontroller. It has a dual mode feature selectable via DIP switch supporting arduino hardware compatible ports and the legacy 8051 ports.

An FMC board with an analog 125 MS/s input and an analog 600 MS/s output for RF applications.

More info at the Wiki page

nanoFIPdiag is a WorldFIP node dedicated to monitoring and diagnostics. It uses the nanoFIP chip in stand-alone mode and echoes the received data (through hardwired contacts it copies the received payload to the produced one). The module is designed to be radiation-tolerant

A fully open electronic watch project featuring an integrated GPS receiver. More info at the Wiki page

Gateware (HDL design) for FMC TDC 1ns 5cha on SPEC and SVEC carriers.

SPIETBOX is a board developed around a SPARTAN-3 FPGA in order to process TTL and SSI encoders. The board is design to work in stand alone or connected to a SPICONTROLLER via the SPI interface.

SAMbuCa I2PS. Used in the SAMbuCa project. More info at the Wiki page

The PZ-TIO is a carrier board for a PicoZed 7015 Zynq System on Module (SoM) supporting White Rabbit in the Zynq PL. It provides Ethernet, UART, SD card and USB peripherals for the Zynq PS running Ubuntu 18; SFPs, WR clocks, and GPIO for the PL.