... | ... | @@ -56,13 +56,21 @@ A: 0 dBm is fine for the logic inside the switch. It is better an higher |
|
|
voltage if you have a sine wave due to better slew rate (noise
|
|
|
immunity). We used about 10 dBm sine wave with excellent results.
|
|
|
|
|
|
- 10 MHz Input Minimum input power: 0 dBm (600 mVpp)
|
|
|
- 10 MHz Input Recommended input power: 3 dBm - 15 dBm
|
|
|
- 10 MHz Input Absolute Maximum input power: 18 dBm (5 Vpp)
|
|
|
|
|
|
Author: Mattia
|
|
|
Rizzi
|
|
|
|
|
|
### Q: What is the required input level for the PPS input on the WRS as a grandmaster?
|
|
|
|
|
|
A: 2V minimum on a 50 ohm load, 2.5V is fine. The input is terminated
|
|
|
with a 50 Ohm, 1% resistor.
|
|
|
A: The input is terminated with a 50 Ohm, 1% resistor. The following are
|
|
|
the PPS input levels:
|
|
|
|
|
|
- PPS Input Minimum: 2.1V (on a 50-ohm load)
|
|
|
- PPS Input Recommended: 2.5V-5V (on a 50-ohm load)
|
|
|
- PPS Input Absolute Maximum: 7 V (on a 50-ohm load)
|
|
|
|
|
|
Author: Mattia
|
|
|
Rizzi
|
... | ... | |