Skip to content

P
Programmable RF Attenuator
Commit 9538cdfb authored by Dimitris Lampridis's avatar Dimitris Lampridis
Browse files
Options

doc: small correction 

no need to remove FTDI driver after EEPROM is programmed
parent 7cb62a29
Hide whitespace changes
Inline Side-by-side
Showing with 1 addition and 1 deletion
doc/docs/factory-testing-procedure.md
View file @ 9538cdfb
......@@ -114,7 +114,7 @@ quitting, please restart the test program
**Preparation**
- You will need the same computer setup that you used for programming the
EEPROM. Once again, please make sure that the `ftdi_sio` driver is not loaded.
EEPROM and the DUT should be already [programmed](#eeprom-programming).
- Get a vector/scalar Network Analyzer (NA) which works at least up to 2 GHz.
- Set the NA to 0dB ref level, S21 measurement, 2 GHz bandwidth, high RBW/VBW
(so that sweeps take short time).
......
Markdown is supported
0% or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment