@@ -19,7 +19,7 @@ The GUI application is presented in :numref:`fig_gui`.
Channels selection:
------------------
Just like in standard oscilloscope, there is a possibility of observing up to 4 channels. Channels from available ADCs could be connected to channels of the GUI.
Just like in standard oscilloscope, there is a possibility of observing up to 4 channels. Any channel of any available ADC can be connected to the particular channel of the GUI.
.. figure:: graphics/GUI_channels_selection.png
:name: fig_gui_chann_sel
...
...
@@ -35,6 +35,8 @@ Just like in standard oscilloscope, there is a possibility of observing up to 4
Triggers selection:
-----------------
The ADCs could be triggered either by external trigger pulse or when signal of the observed channel crosses the threshold value.
.. figure:: graphics/GUI_triggers_selection.png
:name: fig_gui_trigg_sel
:width: 120pt
...
...
@@ -49,6 +51,8 @@ Triggers selection:
Internal trigger:
^^^^^^^^^^^^^^^^
If the internal trigger is selected, the GUI could be triggered on any channel to which a signal is connected.
.. figure:: graphics/GUI_internal_trigger.png
:name: fig_gui_int_trigg
:width: 120pt
...
...
@@ -63,6 +67,8 @@ Internal trigger:
External trigger:
^^^^^^^^^^^^^^^^
If the external trigger is selected, the GUI could be triggered by the external trigger input of any connected ADC.
.. figure:: graphics/GUI_external_trigger.png
:name: fig_gui_ext_trigg
:width: 120pt
...
...
@@ -78,6 +84,13 @@ External trigger:
Channels settings:
----------------
Currently available channels settings are following:
* range
* termination
* offset
.. figure:: graphics/GUI_channels_settings.png
:name: fig_gui_chann_sett
:width: 120pt
...
...
@@ -92,6 +105,12 @@ Channels settings:
Trigger settings:
----------------
Currently available trigger settings are following:
* polarity
* delay
* threshold (in case of internal trigger)
.. figure:: graphics/GUI_trigger_settings.png
:name: fig_gui_trigg_sett
:width: 120pt
...
...
@@ -106,6 +125,11 @@ Trigger settings:
Run control:
---------------
There are two available modes:
* single acquisition
* continuous acquisition
.. figure:: graphics/GUI_run_control.png
:name: fig_gui_run_control
:width: 120pt
...
...
@@ -120,6 +144,8 @@ Run control:
Acquisition settings:
--------------------
Acquisition settings allow to modify the acquisition time and position of the trigger. Position of the trigger is given in percentage of the acquisition time.
.. figure:: graphics/GUI_acquisition_settings.png
:name: fig_gui_acq_set
:width: 120pt
...
...
@@ -128,13 +154,3 @@ Acquisition settings:
:figclass: align-center
Acquisition settings
.. todo::
Make screenshots of all of the components of the GUI and explain shortly
