... | @@ -32,7 +32,7 @@ These documents were presented during the [New WRS-4 Workshop](https://www.ohwr. |
... | @@ -32,7 +32,7 @@ These documents were presented during the [New WRS-4 Workshop](https://www.ohwr. |
|
|**Expansion board** - Mimic the pinout of FMC in the expansion slot|#19|**Accepted**|
|
|
|**Expansion board** - Mimic the pinout of FMC in the expansion slot|#19|**Accepted**|
|
|
|**Expansion board** - Provide proper airflow/cooling for the expansion board|#20|**Accepted**|
|
|
|**Expansion board** - Provide proper airflow/cooling for the expansion board|#20|**Accepted**|
|
|
|**Expansion board** - High speed interface for data (link aggregation)|#21|**Accepted** - route to expansion board GTH/GTY links |
|
|
|**Expansion board** - High speed interface for data (link aggregation)|#21|**Accepted** - route to expansion board GTH/GTY links |
|
|
|**Expansion board** - SAMTEC connector to the expansion board|#42|**Accepted** - after evaluating different options we will use SAMTEC, see (doc to be uploaded)|
|
|
|**Expansion board** - SAMTEC connector to the expansion board|#42|**Accepted** - after evaluating different options we will use SAMTEC, [see](https://ohwr.org/project/wr-switch-hw-v4/uploads/71655353bc093581e62648502a4cb750/WRS-4_Expansion_Connector.pdf)|
|
|
|**Memories** - Add high bandwidth external packet storage|#22|**Rejected** - we are OK with the internal memory|
|
|
|**Memories** - Add high bandwidth external packet storage|#22|**Rejected** - we are OK with the internal memory|
|
|
|**Memories** - A selection criteria for storage could also be TBW (TeraByte Written)|#24 #39|**Accepted** - add mSATA connector|
|
|
|**Memories** - A selection criteria for storage could also be TBW (TeraByte Written)|#24 #39|**Accepted** - add mSATA connector|
|
|
|**Memories** - To speed up configuration of the FPGA one should use Dual QSPI. Is 256 MB QSPI enough?|#24|**Not an issue** Dual QSPI -> for recovery, not programming FPGA|
|
|
|**Memories** - To speed up configuration of the FPGA one should use Dual QSPI. Is 256 MB QSPI enough?|#24|**Not an issue** Dual QSPI -> for recovery, not programming FPGA|
|
... | | ... | |