Mask cooling
Introduction
This wiki page will contain a study of the different possibilities of cooling the UV-mask.
Requirements
- Heat removal: xx W/min
- Low profile
- Power consumption
- Noise level
- Integratable in a mask
- Robust
Project documents
Peltier elements
Fan types
- PulseJets - very flat, innovative heatsinks and fans using oscillating diaphragms
- Sunon mighty mini fan and blower
-
Sepa micro
fans
- Very small but likely not enough flow.
-
Delta Electronics BFB04512HHA-DV52, 45
x 10.3mm
- Blow quite nicely even through a long tube. PWM speed control. 36 dBA which is not super-loud but still quite noticeable at full speed.
-
SEPA HY_45T05A-830 Fan Blower, Radial, 5 VDC, 45 mm, 5 mm, 38
l/min
- They are thinner but shift nearly as much air albeit with a lower static pressure. They are also quieter (27 dBA). The advantage is they are 5V. Also PWM control.
Contact
Status
Date | Event |
---|---|
02-10-2015 | Start at ThePort hackathon, first methods of cooling with fans tried out. |
21-04-2016 | Student will work on studying methods of mask cooling. |
Rémy Soubirane - 28 March 2017