Compact Universal Timing Endpoint Based on White Rabbit with Artix7 - Cute-WR-A7
The Cute-WR-A7 is the enhanced version of the CUTE-WR-DP with an Xilinx Artix7 series FPGA. It inherits similar interfaces from Cute-WR-DP: two SFP ports, two SMA/LEMO connectors, FMC form factor with LPC connector, etc.
The three operation modes of Cute-WR-DP are also supported by Cute-WR-A7:
- Normal mode (Cute-WR-A7-NM)
- In Normal mode, Cute-WR-A7 acts as a normal WR node with one SFP port (SFP0).
- Cascade mode (Cute-WR-A7-CM)
- In CM mode, two ports act as one down-link (SFP1) and one up-link (SFP0) to support cascade topology. Two ports also support a simple switch function for normal Ethernet packets.
- Parallel mode (Cute-WR-A7-PM)
- In PM mode both ports act as down-link port connect to different WRS, provide redundancy to improve the reliability for safety related applications. The current firmware doesn’t support this function.
Contact
Licences
Tags
FMC WR Node White Rabbit FMC Module TRL9 CommercialCompatible Projects
White Rabbit Switch - Hardware
White Rabbit Switch is an open hardware design of an 18-ports Ethernet switch licensed under CERN OHL 1.2
White Rabbit Switch - Hardware V4
This project describes the development of the hardware of the White Rabbit Switch version 4 (WRS-v4)
WRS Fan-less hardware
The White Rabbit Switch is the central element of a White Rabbit network and was designed as a part of the White Rabbit project
WRS with low jitter logic integrated
The White Rabbit Switch Low Jitter (WRS-3-LJ/18) is a new version of the White Rabbit Switch which counts with a series of improvements that enable its use in more demanding time and frequency distribution applications
WRS-318 with LJD prepared hardware
An 18-port White Rabbit switch V3.4 that is prepared for the Low-Jitter Daughterboard