Simple VME FMC Carrier (SVEC)
Project description
The FMC VME Carrier is an FMC carrier that can hold two FMC cards and an SFP connector. The FMC mezzanine slots use low-pin count (LPC) connectors. This board is optimised for cost and will be usable with most of the FMC cards designed within the OHR project (e.g. ADC cards, Fine Delay). For boards needing more possibilities (e.g. programmable clock resources, fast SRAM, fast interconnect between carriers), the VME FMC Carrier - VFC can be used.
Other FMC projects and the FMC standard are described in FMC Projects.
Main Features
- VME64x interface
- VME P2 connector provides access to a Rear Transition Module (compatible to VFC)
- 2 Low-pin count FMC slots
o Vadj fixed to 2.5V
o No dedicated clock signals from Carrier to FMC (as only available on HPC pins and use LPC)
o FMC connectivity: all 34 differential pairs connected, 1 GTP transceiver with clock, 2 clock pairs, JTAG - Main FPGA: Spartan-6 XC6SLX150T-FGG900
- Auxilary (bootup/PLL config) FPGA
o XC6SLX4 - FG256
o Provides VME bootloader, early oscillator/PLL config and FMC detection - Clocking
o 1 10-280 MHz I2C Programmable XO Oscillator (Silicon Labs Si570)
o 25 MHz VCTCXO + 20 MHz VCXO (White Rabbit oscillators)
o Main synthesizer/fanout: AD9516-4 - On-board memories
o 2x 256 MB DDR3 (32-bit bus or wider)
o 1x 32 MB SPI flash for main FPGA firmware storage
o 1x 1MB SPI flash (OTP) for bootup FPGA firmware
o 1x I2C configuration EEPROM (24C16) - Front panel
o 1x SFP port (White Rabbit-compatible)
o 2x (or 4x - depending on the available space) LEMO/SMC programmable I/Os capable of driving 3.3V @ 50 ohm
o 2x eSATA connectors (1 - straight, 2 - crossover)
o 8 Programmable LEDs
o 1x miniUSB connector - Internal connectors
o Xilinx-style JTAG
o VME64x, with some P2 lines going to the main FPGA - FPGA configuration
o from SPI flash or via VME. Default method settable via jumper - Stand-alone features
o PC-style (Molex) 4-pin 12 V external supply connector
Project information
- Official production documentation:
- Users
Contacts
General question about project
- Erik van der Bij - CERN
Status
Date | Event |
01-07-2011 | First ideas for starting this simpler and cheaper version of the FMC VME Carrier. |
19-07-2011 | Main features specification written. |
10-08-2011 | Project on hold as no resources available. |
25-10-2011 | Order sent out to a company for the schematics design. |
10-11-2011 | Schematics design under way. Expect a version to review by end |
17-01-2012 | Expect schematics for review on 25 January. |
25-01-2012 | Received schematics for review. |
01-02-2012 | Schematics design review held. review01022012 |
Erik van der Bij, Matthieu Cattin, Tomasz Wlostowski - 2 February 2012