RF Multiplexer 8ch 1GHz
Project Description
This is a PCB-design + Arduino firmware for an Ethernet-controlled 1:8 RF-multiplexer (SP8T). It allows selecting as output one of eight input-channels, as commonly used e.g. in timing-laboratories when one wants to measure many RF-sources (clock outputs like 1PPS or 10MHz) with a single instrument (frequency or time-interval counter). The unselected channels are terminated at 50 Ohms. The design is for two independent MUX-boards to fit in a 1U 19” rack enclosure together with an Arduino MKR ZERO microcontroller with Ethernet interface. The firmware allows for simple control over http with a browser or e.g. the python requests library.
Main Features
- PDF design files 2018.02: Schematic and PCB
- SP8T: 8 inputs, 1 output. Nominally 50 Ohm characteristic impedance. BNC connectors.
- Bandwidth >1 GHz
- TE HF3 signal realy with lifetime of 1e7 operations (19 years at a rate of one operation per minute)
- older design: Arduino Duo + Ethernet Shield controller
- current design: Arduino MKR Zero + Ethernet Shield controller
- 10/100 Mbit/s Ethernet, simple control over HTTP
Components and datasheets
- TE HF3 Relay
- MCP23S17 16-Bit SPI I/O Expander with Serial Interface
- ULN2803A Darlington Transistor Array
Similar projects
- Open:
- TAPR TASS DC-150 MHz
- k5lxp 6x2 Coaxial Remote Antenna Switch
- Closed/Commercial:
- Pulse Research Labs PRL-8108 DC to 1.5 GHz SP8T multiplexer with 3-bit control.
- Mini-Circuits RC-2SP6T-A12 DC to 12 GHz 2SP6T multiplexer with USB and Ethernet control. SMA connectors.
Contacts
Design and general questions
- Anders Wallin (anders.e.e.wallin "at" gmail.com)
Commerical producers
Status
| Date | Event |
|---|---|
| 2018-02-15 | First PCB revision http://www.anderswallin.net/2018/02/rf-multiplexer-first-try/ |
| 2018-04-25 | Second PCB revision http://www.anderswallin.net/2018/04/rf-multiplexer-version-2/ |
| 2018-06-12 | OHWR-page rf-mux-8ch created |
| 2018-06-17 | initial commit of design to repository: mux-board, due2sata board, enclosure, mux-sw |
| 2018-08 | simplified design with no on-board voltage regulators and 10-pin IDC-cable for control. |
| 2018-11-24 | design update for kicad5 symbols and footprints |
| 2019-09-07 | Arduino MKR Zero carrier board files on wiki |
| 2019-11-27 | Revised carrier for Arduino MKRZero, with front-panel pushbuttons |
Revised front-panel with pushbuttons B1 and B2. From S/N 4 onwards (2019-11).:
Internal view of S/N 4.
Older prototype with Arduino Due:
