calibr_box.py is board specific (the type of box differ depending on the board).
Therefore it is removed from the common pts. If a mean to differentiate between
the box if implemented, it might come back to common pts.

cp210x driver is removed, because it is now stored in the usb-relay-box1 project's repo.

cp210x_eeprom.py is removed, because it is specific to the board (e.g. not the same for fmc-adc)

This function is used by the fmc_delay C library.

Add a first set of common modules from fmcadc100m14b4cha.

Fix C shared library path in rr.py
Remove undefined rr_read and rr_write from rrlib.h
Remove rr.py and rrlib.so from pts root directory.
Put updated versions of rr.py, rrlib.so and rr_loader_lib.so in
test/fmcadc100m14b4cha/python those should be removed when all
tests will use common modules.

Library features are:
- Gennum GPIO configuration
- SPEC boot mode selection (Gennum to FPAG, Genum to Flash or Flash to FPGA)
- Bit bang SPI programming/erase/readback of the Flash
- Force FPGA reload from flash
- FPGA firmware loading using Gennum FCL (= FPGA Configuration Loader)

Function to load FPGA firmware from Gennum added to Python wrapper rr.py

Added the generation of the libfpga_loader shared library. And
comment the output messages of the fpga_loader.

This fpga_loader is only valid for SPEC V2.0 or higher.

The timeout was setup to 1 second (HZ constant in jiffies) to fix a problem
in the test/spec/python/test07.py.

This test file was always waiting for the IRQ from the first DMA.

The DMA transfer was properly finished but the IRQ doesn't arrive. It seems
that the problem behind is a wrong initialization (reset?) of the corresponding
DMA core in the Firmware.

This is a workaround of the problem.

It is not needed because the new bar code reader don't put
a comma between the readings.