Wiki
Summary
The LPC FMC 12 PEXP REV C Board is used to breakout an FMC to digital I/O compatible with PMODs. The design is early prototype stage, and not FMC Standard Compliant* even though it uses an FMC connector. For example if you have rear/front panel FMCs, this board will likely not fit due to it's shape
To Do for REV D
- Read the REV C version and ensure that the dimensions match that of the FMC standard size.
- Use physically smaller resistors.
- Make silk screen say N and P for the SMAs, currently it says N and N!
- Move PMOD further from way of ethernet! Perhaps face upwards not out to the side incase adjacent to other FMC boards.
- Add standoff holes at other end so that the board can be supported by screws if necessary
Links
Pin Layout for SP601 Development FPGA Board