FMC Prototype Board - LPC
The FMC prototype board breaks out the complete LA bank of signals from
the standard FMC Low Pin count Connector and the standard power rail and
control signals.
The user can add standard 0.1 inch spaced components and sockets for a
wide variety of active and passive devices thus enabling the development
of very complex capabilities.
Standard control signals are available for the user to complete the
interface to the chosen carrier card.
The Serdes signals can be accessed from SMA connectors, which could be
soldered on any side of the prototype
card.
Functional Specifications
- VITA 57.1 FMC compliant
- Passive breakout of Low Pin count Connector (LPC) pins to 0.1” matrix grid for soldering or wire-wrapping
- Development 18×16 hole matrix
- Extended Ground rails and Power breakout for two power connections
- User determined VADJ and Vref
- JTAG breakout available in development matrix
- 4 SMA connectors for high speed serial signals (SerDes)
- 125MHz SerDes reference clock
- Control signals available for user connections in development matrix
- On board electrically erasable programmable memory, EEPROM, with 1Kb (128bytes) storage for configuration management and user data
- Supports air and conduction cooling FMC
- Single slot FMC
- -40°C to 85°C operating environment temperature (industrial grade)
Project information
- Production documentation under Documents tab.
Contacts
Commercial producers
- KY-FMC-PRT Kaya Instruments, Israel
General questions about the project
Status
Date | Event |
---|---|
18-05-2017 | First discussions about making this commercial board design available as Open Hardware. |
06-06-2017 | Creation of entry on ohwr.org. |
6 June 2017