Fine Delay Functional Specifications
The FMC Delay 1ns-4cha is an FPGA Mezzanine Card (FMC - VITA 57
standard), whose
main purpose is to produce pulses delayed by a user-programmed value
with respect to the
input trigger pulse. The card can also work as a Time to Digital
converter (TDC) or as a
programmable pulse generator triggering at a given TAI time.
Modes of operation
Fine Delay can work in one or more of the following modes:
-
Pulse Delay: produces one or more pulse(s) on selected outputs a
given time after an input
trigger pulse (fig. 1a) -
Pulse Generator: produces one or more pulse(s) on selected
outputs starting at an absolute
time value programmed by the user (fig. 1b). In this mode, time base is usually provided
by the White Rabbit network. -
Time to Digital Converter: tags all trigger pulses and delivers
the timestamps to the user’s
application.
Modes (pulse delay/generator) can be selected independently for each
output. For example, one
can configure the output 1 to delay trigger pulses by 1 us, and the
output 2 to produce a pulse
at the beginning of each second. The TDC mode can be enabled for the
input at any time and
does not interfere with the operation of the channels being time tagged.
Electrical
Inputs/Outputs:*
- 1 trigger input (LEMO 00)
- 4 pulse outputs (LEMO 00)
- 2 LEDs
- Carrier communication via 160-pin Low Pin Count FMC connector
Trigger input:*
- TTL/LVTTL levels, DC-coupled. Reception of a trigger pulse is
indicated by blinking the
"TRIG" LED in the front panel. - 2 kOhm or 50 Ohm input impedance (programmable via software). 50 Ohm
termination is
indicated by the "TERM" LED in the front panel. - Power-up input impedance: 2 kOhm.
- Protected against short circuit, overcurrent (> 200 mA) and overvoltage (up to +28 V).
- Maximum input pulse edge rise time: 20 ns.
Outputs:*
- TTL-compatible levels DC-coupled: Voh = 3 V, Vol = 200 mV (50 Ohm
load), Voh = 6
V, Vol = 400 mV (high impedance). - Output impedance: 50 Ohm (source-terminated)
- Rise/fall time: < 2 ns (10 - 90, 50 Ohm load)
- Power-up state: LOW (2 kOhm pulldown), guaranteed glitch-free.
- Protected against continuous short circuit, overcurrent and
overvoltage (up to +28 V).
Power supply: - Used power supplies: P12V0, P3V3, P3V3 AUX, VADJ (voltage monitor only).
- Typical current consumption: 200 mA (P12V0) + 1.5 A (P3V3).
- Power dissipation: 7 W. Forced cooling is required.
Mechanical/Environmental
Mechanical and environmental specs:*
• Format: FMC (VITA 57), with rear zone for conduction cooling
• Operating temperature range: 0 - 90 degC.
• Carrier connection: 160-pin Low Pin Count FMC connector
Fig 1.* Illustration of Delay/Pulse Generator mode operation.