Open
Milestone
EDA-03849-V2
Version 2 PCB of the eRTM14
Unstarted Issues (open and unassigned)
1
Ongoing Issues (open and assigned)
0
Completed Issues (closed)
25
- B2B connector signal mapping issues
- eRTM14: power source selection not clear
- eRTM14: RFU_LVCMOS harness has no signal names
- eRTM14: consider removing USB_VBUS bypass cap
- Copyright notices should be 2018-2019
- eRTM14: Remove notes regarding adjustment of series termination for FLASH signals
- ertm14: put RC/LC filters on the OCXO DAC SPI signals
- ertm14: drop CAL lines from the FPGA/B2B connector
- eRTM14/15: front panel labels upside down
- eRTM14/15: follow MTCA standard with the LEDs
- ertm14: layout optimization
- ertm14: bypass capacitors
- use STLink-V2 compatible JTAG connector for the MMCs
- ertm14: remove external PHY calibration circuit
- eRTM15: 100 MHz OCXO option
- Powering from MCH
- ertm14: Move MMC JTAG connector
- Replace LEDs with a small display
- USB UART improvements
- ertm14: eeprom (with MAC) is too small to keep FRU information
- Line to reset FPGA is pulled up and down
- Schematics: Wrong I2C address of a temp sensor
- Add a RX to the debug uart to STM32
- LED_SYNC shall be conected to FPGA not to STM32
- STM32 does not support ITM trace