Closed
Milestone
v2.0
Unstarted Issues (open and unassigned)
0
Ongoing Issues (open and assigned)
0
Completed Issues (closed)
40
- Modify powering scheme, move from FEAST and LT3083 to bPOL12V
- Replace MURATA DLW5BSN191SQ2L (L1) with DLW5BSM191SQ2L
- power cycle pulse generator
- Smart Debugger Pins
- PGOOD behind I2C Expander
- FMC PG_C2M
- Use net before shunt resistor for powering the current sense differential amplifier
- SERVMOD_DIR pull up/down
- FLASH_MISO needs a pull-up
- front panel LEDs too short to reach the front panel
- SERVMOD signals going to the backplane should be pulled up (not down) after the voltage translating buffer
- add 2nd via to take PPeriph from L1 to L4PWR
- some vias are not covered with soldermask
- correct GND polygon around IC34
- move P2V5_PLL_VSSA polygon to L10 and expand CPCIS_12V polygon around J21
- remove v1.0 PcbDoc from the project
- Schematics validation reports conflicting harness definitions for FMC-LA_SE
- Connect RSTON from nanoFIP to power cycle request circuit
- Bpol12V Solder mask layer
- sch: remove JTAG selector jumpers drawing
- remove IC25 I/O expander
- FMC.Sch: use only PGOOD_FMC to drive PG_C2M
- unrouted net P12V_SHUNT
- Avoid 4-way connections in the schematic
- Jumper selection for Igloo2 JTAG
- Powering: replace jumper for PPERIPH selection with 0R resistors. P2V5 selected by default
- Update Board version resistor net
- SERVMOD signal should be translated to P3V3 (not PPERIPH)
- review names of signals of DI/OT backplane P1-P6 connectors
- Connect reset generated by nanoFIP to DEVRST_N of Igloo2
- Replace Dialight 592-2323-302F - it's obsolete
- Replace TPS7A4533DCQ with LM317D2TG
- Replace Monimod with AD7291 ADC
- Replace LT3083
- Do not mount crystal Q3 connected to XTLOSC_MAIN_*
- Replace OPA192 with OPA2192ID
- Revisit pcb version
- Add a reset button (for debugging)
- Make FMC JTAG pull-{up,down} resistors unmounted by default
- V1 - No link to project sources on the PCB silkscreen