Open
Milestone
crate v1.2
All issues for this milestone are closed. You may close this milestone now.
Unstarted Issues (open and unassigned)
0
Ongoing Issues (open and assigned)
0
Completed Issues (closed)
21
- BOM: update AUX connector ribbon cable and backplane connector
- BOM: add CPCI-Serial backplane guiding element
- BOM: update link to PCB Front Panel
- Wiring diagram: wrong SW1 dip switch configuration
- IDC ribbon cables plugs not matching well IDC sockets on the main and power backplane
- Bug in the Cabling Manual
- Add grounding screw and associated winged nut to the BOM
- Main backplane guiding element is not mounted. This should be corrected in the backplane Kicad design.
- Add ESD contacts in guiding rails
- Add EMC gasket for aluminium bars holding top and bottom perforated covers
- Use more ergonomic handles
- Power backplanes dip switches configuration
- Do not mount backplanes grounding screws by default
- Power cables 12V, GND, 5V arrangement and thickness
- front dividing plate is very close to the 230VAC contacts of the relay, should have some insulation layer added
- update BOM with new LSZH cables after prototypes assembly
- BOM lists only 1 power backplane, it should be 2 power backplanes per crate
- Front panel AUX D-SUB connector pinout missing in the specification
- Consider replacing power entry module FN281-2-06 with FN282-2-06
- Fan Tray connector: incompatibility between 16pin IDC on the backplane and 15-pin D-SUB on the front panel
- [Crate Front Panel] Dimensions and Isolation Plate