[mechanics] 3-board assembly
- in the EDA-04213, connectors J1, J2 should be moved a bit to the left (towards the front panel). After making a PCB mockup the front panel PCB pushes too much with J1/J2 on the power backplane causing it to bend. Check in with 3D model exact location of these connectors.
- could we make EDA_04212 smaller (in X dimension) by a fraction of mm at the edge where connectors J3/J4 are placed? When sliding the front panel PCB, through hole pins of its utility connector rub slightly the PCB edge. Maybe J3/J4 need to be also moved by a fraction of mm?