Commit 07e07988 authored by Denia Bouhired-Ferrag's avatar Denia Bouhired-Ferrag

DOC: minor mods to manual

parent 3636dce5
......@@ -361,6 +361,7 @@ TTL channel on the front panel.
\caption{\label{fig:oterm} Output termination enable}
\end{figure}
\subsection{Input and output termination }
Each RS-485 output on a channel has its dedicated transceiver capable of driving 256 nodes. Additionally,
each input and output channel has a selectable 100~$\Omega$ termination, which can be enabled by the
input and output termination switches (see Section~\ref{sec:switches}). Setting the input or output
......@@ -372,7 +373,7 @@ Finally, when a pulse is repeated on the output connector of a channel, the puls
\centerline{\includegraphics[width=.8\textwidth]{fig/iterm}}
\caption{\label{fig:iterm} Input termination enable}
\end{figure}
%======================================================================================
% SEC: Switches
%======================================================================================
......
Markdown is supported
0% or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment