Skip to content

C
Conv TTL Blocking
Commit ee6f438e authored by Federico Vaga's avatar Federico Vaga
Browse files
Options

doc: add frequencies operation 

Signed-off-by: Federico Vaga's avatarFederico Vaga <federico.vaga@cern.ch>
parent 795446e8
Hide whitespace changes
Inline Side-by-side
Showing with 9 additions and 0 deletions
doc/ug/ug-conv-ttl-blo.tex
View file @ ee6f438e
......@@ -378,6 +378,9 @@ Section~\ref{sec:diag-sw-rtmdet}).
SW1.1 & Glitch filter enable (see Section~\ref{sec:pulse-jit}) \newline
\textbf{ON} -- glitch filter enabled, output jitter present \newline
\textbf{OFF} -- glitch filter disabled, no output jitter (default) \\
SW1.2 & Pulse width \newline
\textbf{ON} - short pulse width [250 ns] \newline
\textbf{OFF} - long pulse width [1.2 us] (default)\\
SW2.4 & TTL/TTL-BAR selection switch (see Section~\ref{sec:pulse-ttl-vs-ttlbar}) \newline
\textbf{ON} -- TTL channels receive and generate TTL (default) \newline
\textbf{OFF} -- TTL channels receive and generate TTL-BAR \\
......@@ -681,6 +684,12 @@ can be left in the \textbf{OFF} position.
\noindent Note 1: If the glitch filter is enabled, it adds an extra 350~ns delay to $t_{PD}$. \\
\noindent Note 2: Measured visually using cursors on an oscilloscope.
%--------------------------------------------------------------------------------------
% SUBSEC: Pulse jitter and delay
%--------------------------------------------------------------------------------------
\subsection{Frequencies operation}
\label{sec:freq-op}
%======================================================================================
% SEC: Communicating to the CONV-TTL-BLO
%======================================================================================
......
Markdown is supported
0% or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment