Explore projects

This library provides a generic API for ADC devices, so that applications can use this API to access any of the supported ADC boards. Currently the library supports the following boards:

fmc-adc-100m14b14cha

For testing and debugging purpose it supports also a couple of virtual boards that you can use to start the development of your application.

More info at the Wiki page

This library provides a generic API for ADC devices, so that applications can use this API to access any of the supported ADC boards. Currently the library supports the following boards:

fmc-adc-100m14b14cha

For testing and debugging purpose it supports also a couple of virtual boards that you can use to start the development of your application.

More info at the Wiki page

Firmware(gateware) for FPGA on AIDA-Innova TLU ( AIDAInnova_TLU )

A system to characterize large area silicon pad sensors with several hundred channels. This repository contains the microcontroller firmware.

A system to characterise large area silicon pad sensors with several hundred channels. It consists of two PCBs. One is an active switching 512-to-1 matrix. The second one is a passive probe card to contact the sensor. Software.

A low cost, low complexity FMC carrier based on Xilinx Artix-7

BabyWR is a general purpose small pluggable WR node in a M.2 form-factor. More info at the Wiki page

Gateware for Beam Position Monitor, including digital signal processing chains, data acquisition engines, ADC and analog front-end peripherals control/monitoring, timing and control system interface.

Software for Beam Position Monitor, including digital signal processing chains, data acquisition engines, ADC and analog front-end peripherals control/monitoring, timing and control system interface.

A cute-wr is a compact WR-node implementation with minimum components required. The initial design is derived from SPEC, but would work in an opposite manner as a FMC wr-nic, providing 2 DIO channels, external CLK input, EEPROM, JTAG, RS232, and expandable IOs through FMC connector. The gateware and software of cute-wr would also keep maximum compatibility with SPEC. Project is obsolete. See cute-wr-dp for a similar board.

Common gateware for the different level conversion circuits.

Data centre environmental sensor - Dust, Temperature, Relative Humidity, Fan - Serial 1 channel - version 1. An environmental sensor for Data Centers that continuously measures airborne particle density in high airflow as well as temperature and relative humidity. It can control its fan speed if needed (PWM controlled fans) and monitors FAN rotational speed (tachometer equipped fans) for precise airflow control and monitoring. It is close to maintenance free and can be integrated in compact enclosures (for example tape drive tray or even an ATX PSU case...). More info at the Wiki page

SAMD21-based monitoring module for DI/OT power supply and fan tray.

This project contains gateware for the Distributed IO Tier demonstrator according to the CERN Warm Interlocks specification

EPICS support for Wishbone peripherals: This project consist of a Generic EPICS IOC AsynDriver to support wishbone peripheral. It include the following features:

Driver for X1052, Gennum, Etherbone WB master. Direct access to any register in the wishbone bus Auto-generation of EPICS Database file using wbgen2 Automatic real number convertion (2 complements, fixed point, signess) using .wb file Support for WR Core and other internal bus protocols (i2c, spi, etc.)

More info at the Wiki page

Etherbone is an FPGA-core that connects Ethernet to internal on-chip wishbone buses permitting any core to talk to any other across Ethernet.

FmcAdc100M14b4cha is a 4 channel 100MSPS 14 bit ADC low pin count FPGA Mezzanine Card (VITA 57). More info at the Wiki page

Software to support the fmc-adc-100m14b4cha mezzanine, including Linux device driver, library and test program.